ATW-1501 Stompbox Guitar and Bass Wireless System with Floor Pedal
Free yoruself to move around stage without tripping over your lead. The Stompbox Wireless System provides a rock solid solution for guitarists, bass players, and other instrumentalists who require pro-level versatility and high-end quality audio. It provides 24bit/96KHz digital audio. If you have multiple instruments that you would like to use wirelessly, the Stompbox unit can pair with up to 8 body-pack transmitters. The Stompbox also acts like an ABY switch, allowing you to switch between either 2 amps, or an amp and a tuner. The package comes with an an ATW-R1500 Stompbox receiver, an ATW-T1001 UniPak body-pack transmitter, an AT-GcW high quality guitar cable, and hook and loop strips for adding the Stompbox receiver to an effects pedal board
Multiple Diversity Methods
System 10 wireless ensures clear communications by providing three levels of diversity assurance: frequency, time, and space. Frequency Diversity sends the signal on two dynamically allocated frequencies for interference-free communication. Time Diversity sends the signal in multiple time slots to maximize immunity to multipath interference. Finally, Space Diversity uses two antennas on each transmitter and receiver to maximize signal integrity.
Rugged Foot Pedal Receiver
The Stompbox is a metal, pedal board mountable receiver with a rugged, heavy duty design. The rear panel has a selector switch, giving you complete control over the receiver’s two TRS balance 1/4″ outputs. Witha tap of the foot, you can either toggle between the two outputs, or, mute or unmute one output without muting the other output. It has an easy-to-read digital display with system ID number,and also has battery level indicators. It operates on 12V DC, either using the included power supply or from the pedal boards power source.
Features:
- Audio-Technica’s innovative digital wireless guitar system
- 2.4GHz range – licence free and far from TV and DTV interference
- Stompbox design to fit comfortably on a pedalboard
- 9v or 12v negative or positive power to match pedal board power supplies
- A-B box to toggle outputs or mute for tuning
- Pair up to 8 guitars to one receiver with separate bodypack receivers
- Ideal for guitar, bass or any other jack input instruments
- Complete system with bodypack transmitter, stompbox receiver, guitar cable and power supply
Specifications:
Overall System
| Operating Frequencies | 2.4GHz ISM band (2400 to 2483.5MHz) |
| Dynamic Range | >109dB (A-weighted), typical |
| Total Harmonic Distortion | <0.05% typical |
| Operating Range | 18.3m (60′) radius, 36.6m (120′) diameter typical Open range environment with no interfering signals |
| Operating Temperature Range | 0° C to +40° C (32° F to 104° F) Battery performance may be reduced at very low temperatures |
| Frequency Response | 20Hz to 20kHz Depending on microphone type |
Receiver
| Receiving System | Diversity (frequency/time/space) |
| Maximum Output Level | 1/4″ (6.3mm), TRS balanced: +12dBV |
| Power Supply | 100-240V AC (50/60 Hz) to 12V DC .5A (center positive) switched mode external power supply |
| Dimensions | 101mm (3.98″) W x 44mm (1.73″) H x 130mm (5.12″) D |
| Net Weight | 565grams (19.9oz) |
| Accessories Included | Power supply, hook & loop fastener x2 |
Body-Pack Transmitter
| RF Power Output | 10mW |
| Spurious Emissions | Following federal and national regulations |
| Input Connections | Four-pin Locking Connector Pin 1: GND Pin 2: INST INPUT Pin 3: MIC INPUT Pin 4: DC BIAS +9V |
| Batteries | Two 1.5V AA not included |
| Battery Life | >7 hours (alkaline) Depending on battery type and use pattern |
| Dimensions | 70.2mm (2.76″) W x 107.0mm (4.21″) H x 24.9mm (0.98″) D |
| Net Weight | 100grams (3.5 oz) without batteries |
| Accessory Included | AT-GcW Guitar Input Cable |















Reviews
There are no reviews yet.